BGP Attribute

-




bgp

Comments

Post a Comment

Popular posts from this blog

How to Upgrade Software on Cisco 5508/5520 HA WLC

-
Image
The process to upgrade a Cisco Wireless Lan Controller is quite straightforward but there are a few things you need to be aware of which can minimise the downtime for your wireless network. This guide will go through the process to upgrade a pair of 5508 WLC’s configured in HA setup and connected back to back with RP port. Here is the Topology: Upgrade Software on Cisco 5508/5520 WLC – Steps The first step is to upload the new image to the controller. This process does nothing to your live network and only uploads the image to the controller. Download the image from  cisco.com  and store in a known location on your laptop. For the purpose of this guide I am using 8.0.121.0 .Don't forget to check compatible matrix for your AP Models.  You will need a TFTP server running, I am using TFTPD32 running locally on my laptop. You can also use FTP or SFTP server to transfer the image.  Copy the new image into your tftp directory and go to the GUI on your controller
Read more

How to upgrade software on a Cisco 3850 Switch | Recover Password | Configuration Backup | Restore Configuration

-
Image
This short post will show you how to upgrade the software on a single Cisco 3850 switch or a 3850 stack, using TFTP and USB. The process is very easy but it is a bit different than the usual software image of previous switches i.e 3750 etc. The main difference is the Cisco 3850 switch run IOS-XE so you have to copy the .bin file to the flash on the switch and then install the software on the switch. Download the required image from cisco.com Begin the install Reboot the switch Step 1 copy the new image to the 3850 3850-SW1# copy tftp flash Address or name of remote host []? 10.1.1.100 Source filename []? cat3k_caa-universalk9.SPA.03.03.01.SE.150-1.EZ1.bin Destination filename [cat3k_caa-universalk9.SPA.03.03.01.SE.150-1.EZ1.bin]? Accessing tftp://10.1.1.250/cat3k_caa-universalk9.SPA.03.03.01.SE.150-1.EZ1.bin… Loading cat3k_caa-universalk9.SPA.03.03.01.SE.150-1.EZ1.bin from 10.251.226.253 (via Port-channel1): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Read more

STP Interview Questions and Answers [CCNP]

-
What is STP & Redundant Links? Spanning Tree Protocol (STP) is a protocol which prevents layer 2 loops. STP enables switches to become aware of each other so that they can negotiate a Loop-Free path through network. In practical Scenario, Redundant links are created to avoid complete network failure in an event of failure of one link. How STP works? STP chooses a Reference point (Root Bridge) in the network and calculates all the redundant paths to that reference point. Than it picks one path by which to forward frames and blocks other redundant paths. What are the different port states? 1. Disabled - A port in the disabled state does not participate in the STP. 2. Blocking - A blocked port does not forward frames. It only listens to BPDUs. The purpose of the blocking state is to prevent the use of looped paths. 3. Listening - A port in listening state prepares to forward data frames without populating the MAC address table. The port also sends and listens t
Read more